SOLVED Open core and Monterey Installation problems

[Innovatekgalatina]

It could be possible. Attach your EFI to check.

here you go, thanks in advance and I hope you can solve this problem for me.

 

[EliteMacx86]

As expected, your EFI is not as per the guide.

Start here:

 

[Innovatekgalatina]

As expected, your EFI is not as per the guide.

Start here:

even following this guide the error is always there, then I tried to redo the efi via dortania's guide but the error is always there

 

[EliteMacx86]

even following this guide the error is always there, then I tried to redo the efi via dortania's guide but the error is always there

Don't rush. Firstly create the EFI from scratch as per the guide linked above and we'll see how it goes.

 

[Innovatekgalatina]

Don't rush. Firstly create the EFI from scratch as per the guide linked above and we'll see how it goes.

nothing changed, same errors. I'm redoing the operating system partition in case that one is damaged

 

[EliteMacx86]

nothing changed, same errors. I'm redoing the operating system partition in case that one is damaged

No idea without the new EFI you created. If you created/fixed the EFI, attach it here to cross check.

 

[Innovatekgalatina]

No idea without the new EFI you created. If you created/fixed the EFI, attach it here to cross check.

 

[Innovatekgalatina]

Nessuna idea senza il nuovo EFI che hai creato. Se hai creato/corretto l'EFI, allegalo qui per un controllo incrociato.

it gets stuck here

 

[EliteMacx86]

it gets stuck here

Why are you using USBInjectAll and UTBMap together? Use USBInjectAll as per the guide and map the ports during post installation.

Also, you must add -igfxvesa in the boot arg.

IgnoreInvalidFlexRatio is required for BDW and older.

 

[Innovatekgalatina]

Why are you using USBInjectAll and UTBMap together? Use USBInjectAll as per the guide and map the ports during post installation.

Also, you must add -igfxvesa in the boot arg.

IgnoreInvalidFlexRatio is required for BDW and older.

I created utbmap by mapping the pre-installation ports. IgnoreInvalidFlexRatio in the video guide remains active but I will deactivate it. I will try as you told me and let you know. thanks