UHD 630 not working

[YosiCoco]

what i need fix? i uploaded efi - https://easyupload.io/ddf9zn

This is because your Display is connected to NVIDIA instead of IGPU and probably, in headless mode

i'm connected to the motherboard

Framebuffer patching is required.

i did

 

[EliteMacx86]

what i need fix? i uploaded efi - https://easyupload.io/ddf9zn

i'm connected to the motherboard

i did

Use Google Drive to upload.

 

[YosiCoco]

EFI.zip

drive.google.com

 

[EliteMacx86]

EFI.zip

drive.google.com

Framebuffer is not patched correctly. Replace the X with your actual connector, if they exists. Read the guide again.

 

[YosiCoco]

con0 con1 con2...? that what you mean?

 

[YosiCoco]

same problem, but thank you

 

[EliteMacx86]

con0 con1 con2...? that what you mean?

It depends on what your physical connectors are

same problem, but thank you

No PR files attached.

 

[YosiCoco]

It depends on what your physical connectors are

i use display port, so i used con1

EFI.zip

drive.google.com

my new EFI

 

[EliteMacx86]

i use display port, so i used con1

EFI.zip

drive.google.com

my new EFI

The config.plist is still not cleaned up properly.

Configure the following in your config.plist

- Disable the following Quirks from ACPI>Quirks section

• FadtEnableReset
• RebaseRegions

- Disable the following Quirks from Booter>Quirks section

• EnableWriteUnprotector

- Enable the following Quirks from Booter>Quirks section

• RebuildAppleMemoryMap
• SetupVirtualMap

- Set Picker Attributes to 17 in Misc>Boot section
- Disable PollAppleHotKeys in Misc>Boot section
- Set Expose Sensitive Data to 6 in Misc>Security section
- Enable AllowNvramReset option in Misc>Security section
- Add -wegnoegpu as bootarg in NVRAM section

Save changes, restart, reset NVRAM twice, use onboard DP to boot into macOS. Reply with new complete set of PR files.

 

[YosiCoco]

- Enable AllowNvramReset option in Misc>Security section

i don't see it