Clover's menu never shows up when put EFI\Clover\drivers\UEFI\ApfsDriverLoader.efi

[EliteMacx86]

Finally i can control this issue, can sure reason cause my "special" behavior while load efi drivers.
All what i did is set ApfsDriverLoader.efi (and HfsPlus.efi, if need for installation macOS with Clover, yes)
Firstly put ApfsDriverLoader.efi and HfsPlus.efi in root of EFI partition.
Boot into Clover GUI, press S to open EFI Shell:

1. fsx: #x depend your partitions layout, mine is 0
2. ls #check for sure x is correct part, if that you will see ApfsDriverLoader.efi and HfsPlus.efi
3. bcfg driver add y fsx:\ApfsDriverLoader.efi "What ever name"

In my case, I add both ApfsDriverLoader.efi and HfsPlus.efi so these my cmd:
bcfg driver add 0 fs0:\ApfsDriverLoader.efi "Apfs Driver"
bcfg driver add 1 fs0:\HfsPlus.efi "HFS+ Driver"

Then type: exit to out of EFI She'll/ or just Ctrl+Alt+Del to reboot device, Clover will autoload EFI and show macOS to boot

*NOTE: bcfg will store EFI drivers in NVRAM, so if reset NVRAM will be gone, must repeat above process




View attachment 4951

What is loader here?

 

[oldman20]

What is loader here?

What ur mean? it auto load apfs and hfs+ to show Mac OS partition in case cloverGUI stuck went boot with these efi driver in Drivers folder

 

[EliteMacx86]

What ur mean? it auto load apfs and hfs+ to show Mac OS partition in case cloverGUI stuck went boot with these efi driver in Drivers folder

I see a loader in shell.

 

[oldman20]

I see a loader in shell.

yes but stuck to show macOS part to boot