Recent content by jenerdba

Attached my EFI.

The total CPU threads is 61. Tried Big Sur and got stuck at "SerialATAPI Initial device configuration did not complete successfully. (failedCommandInfo = 0x4)" Screenshot attached.

I'm attaching the BIOS manual for reference. This is what I have set: AiTweaker Menu: Xeon Turbo Charger = Enabled Advanced Menu: ACPI Settings - Enable ACPI Auto Configuration = Enabled NCT7669D Super IO Configuration - Serial Port 1 and 2 = Disabled Onboard LAN I210 - LAN ROM Type = Disabled...

I switched to Ventura and got it to boot the installer. Well... sort of. I have two CPUs so I had to add CPUS=1 in the boot args. But now it get stuck on AHCI PRT Abort Commands (screenshot attached). Any ideas?

I renamed PCI to PC00 and recompile the SSDTs. But I'm getting the same KP. I checked my DSDT (attached) and I don't have a PC00 device in it. Any other suggestion?

Hi, Attached is my EFI. Thank you!

Hello Everyone, I'm trying to install Monterey on my PC and I created an OpenCore 0.9.1 USB drive following the installation guide in this forum. My config is as follow: Motherboard: ASUS Z10PE-D8 WS CPU: Dual Intel Xeon E5-2697 v3 Video: AMD Radeon RX 6600 Audio: Internal (Realtek ALC-1150)...